JLR-10 Instruction Manual.pdf - Echomaster Marine Ltd.
JLR-10 Instruction Manual.pdf - Echomaster Marine Ltd.
JLR-10 Instruction Manual.pdf - Echomaster Marine Ltd.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>JLR</strong>-<strong>10</strong> GPS Compass<br />
5. Solering a center contact<br />
Fig. A-15<br />
Soldering<br />
• Solder core wire for preparation, insert a center<br />
contact, and solder it pouring solder from the hole<br />
of center contact.<br />
• Solder not to make a gap between the center contact<br />
and the insulator.<br />
Check solder leaking and fillet, and confirm<br />
whether solder is firmly attached by pulling the<br />
center contact.<br />
• Using solder : RH-60 1.0<br />
Solder iron<br />
Temperature sensor<br />
6. Fixing a insulator<br />
Insulator of the cable<br />
• Insert a insulator of the connector into a block soldered<br />
the center contact.<br />
Fig. A-16<br />
7. Fixing into a connector<br />
Tightening with spanner<br />
• Fix the cable block into the connector with warning<br />
against gaps between each parts.<br />
• Thrust by hand at first, and bound tight using a<br />
torque wrench.<br />
CAUTION)<br />
1. When tightening with spanner, don't<br />
scar the connector or tightning parts.<br />
2. Don't keep loosen the tightning parts.<br />
Fig. A-17<br />
<strong>10</strong>4