Warrior Skills Level 1 - Leader Development for Army Professionals

Performance Steps
j. Secure the DAP.
k. Don the ACH.
7. Decontaminate your individual equipment using your individual equipment
decontamination kit, as necessary.
8. Notify your supervisor of any suspected CB hazard/attack.
9. Continue the mission and perform any additional requirements as outlined in
your unit's standing operating procedure (SOP).
Note:
1. Use all means of CB detection to check your surrounding area for the presence of
contamination.
2. Contact your higher headquarters if you find contamination or if you determine that the
attack was non-CB related.
3. Await further guidance. The higher headquarters contacts all adjacent/attached units to
check the status of CB contamination in their areas. All units will report the absence or
presence of contamination to the chain of command.
4. Annotate the above actions on your duty log (DA Form 1594, Daily Staff Journal or
Duty Officer's Log).
Evaluation Preparation: Setup: A good time to evaluate this task is
during a field exercise when a variety of CB hazards can be simulated.
Select a site with adequate cover, and ensure that Soldiers have their
assigned protective mask.
Brief Soldier: Tell the Soldier that there will be an encounter with
simulated CB agents and/or a CB alarm will be given.
Performance Measures GO NO GO
1. Identified automatic-masking criteria. —— ——
a. Stopped breathing.
b. Put on mask with hood.
c. Cleared mask.
d. Checked mask.
e. Did not fasten the hood.
f. Went at once to the next step.
2. Donned protective mask without fastening the hood
within 9 seconds.
a. Vocally.
—— ——
b. Used arm and hand signals.
STP 21-1-SMCT 2 May 2011 3-121