CETAC M-7600 Mercury Analyzer Operator's Manual

CETAC QuickTrace M-7600 Mercury Analyzer
Chapter 1: Introduction
‣ Peristaltic Pump. A four-channel peristaltic pump is built into the front of
the mercury analyzer.
The following components are located on the back of the analyzer:
‣ POWER Switch. Turns power to the M-7600 mercury analyzer on and off.
This switch also controls power to the autosampler, when powered
through the mercury analyzer.
‣ Gas Ports. Gas inlet and exhaust ports.
‣ Mercury Trap. The trap scrubs mercury from the exhaust gas.
The following electrical connectors are located on the back of the analyzer:
‣ Ethernet Port. The Ethernet port is used to interface the mercury
analyzer with the host computer.
‣ Auxiliary Communication Ports. The two AUX I/O ports and one AUX
INPUT port are reserved for use with other CETAC instruments.
‣ Power Output Connectors. Provides power for the autosampler and for
an optional auxiliary device.
Supplied Equipment
The following standard components are supplied with the mercury analyzer:
‣ M-7600 Mercury Analyzer.
‣ CD. The CD contains:
• QuickTrace software
• This manual
• Other application-specific information
‣ Gas-Liquid Separator.
‣ Perma Pure ® Dryer Cartridge. Uses a DuPont Nafion ® membrane to
remove humidity from the sample gas. The cartridge is pre-installed in the
mercury analyzer.
‣ KMnO 4 Absorbent Trap. This scrubs mercury from the exhaust gas. The
KMnO 4 is not included.
‣ Bottles. One reagent bottle and one rinse bottle are provided.
‣ PCI Ethernet Adapter Board.
‣ Power Cord and Cables. An Ethernet cable, a power cord for the mercury
analyzer, and a power cord for the autosampler are supplied.
Depending on how the system was ordered, the following optional equipment
may be supplied:
‣ Computer. The mercury analyzer may be ordered with a computer which
is pre-configured with the QuickTrace software.
‣ CETAC ASX-520/260/130 Autosampler.
‣ CETAC ADX-500 Autodilutor.
‣ ENC-500 Enclosure.
13