CETAC M-7600 Mercury Analyzer Operator's Manual
CETAC M-7600 Mercury Analyzer Operator's Manual
CETAC M-7600 Mercury Analyzer Operator's Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>CETAC</strong> QuickTrace M-<strong>7600</strong> <strong>Mercury</strong> <strong>Analyzer</strong><br />
Chapter 3: Installing the <strong>Analyzer</strong><br />
Step 4: Connect Power and Data Cables to the Back<br />
of the <strong>Mercury</strong> <strong>Analyzer</strong><br />
1 Locate the plastic shipping bag labeled “Completion Kit – QuickTrace M-<br />
<strong>7600</strong>.” It contains various power and data cables, small parts, tubing, fittings,<br />
computer CD-ROM, etc.<br />
You will be locating supplies from in kit for throughout the installation process.<br />
It is recommended to leave the parts in this bag, in their original packaging,<br />
until you need them.<br />
2 Place the autosampler power switch in the OFF position.<br />
3 Place the mercury analyzer power switch in the OFF position.<br />
M-<strong>7600</strong><br />
Power Switch<br />
Figure 3-26<br />
Power Switch<br />
4 Connect the line cord to the connector on the back of the mercury analyzer.<br />
If the cord is not of the correct type for your country, contact <strong>CETAC</strong><br />
Technologies. See “Power Cord Set Requirements” on page 151.<br />
Figure 3-27<br />
Power Cord Connected to <strong>Mercury</strong> <strong>Analyzer</strong><br />
5 Connect the power cord into a grounded surge protected power strip.<br />
6 Plug the surge protected power strip into the AC outlet receptacle.<br />
Do not turn on the power switches yet.<br />
39
Change language