CETAC M-7600 Mercury Analyzer Operator's Manual
CETAC M-7600 Mercury Analyzer Operator's Manual
CETAC M-7600 Mercury Analyzer Operator's Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>CETAC</strong> QuickTrace M-<strong>7600</strong> <strong>Mercury</strong> <strong>Analyzer</strong><br />
Chapter 3: Installing the <strong>Analyzer</strong><br />
Figure 3-68<br />
Selecting the Autosampler Model.<br />
8 Select the autosampler COM port.<br />
The autosampler is connected via USB, but the USB driver emulates a serial<br />
(COM) port. The driver automatically assigns a COM port number of COM3 or<br />
greater.<br />
Figure 3-69<br />
Selecting the Autosampler COM port.<br />
9 Start the QuickTrace software.<br />
10 When the software is initializing, it will test the connections to the<br />
QuickTrace M-<strong>7600</strong> mercury analyzer and the autosampler.<br />
The QuickTrace M-<strong>7600</strong> software runs a test routine at startup to test the<br />
various interfaces throughout the system. The software will give a report on<br />
the status of the interface if there is a failure.<br />
67