CETAC M-7600 Mercury Analyzer Operator's Manual
CETAC M-7600 Mercury Analyzer Operator's Manual
CETAC M-7600 Mercury Analyzer Operator's Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>CETAC</strong> QuickTrace M-<strong>7600</strong> <strong>Mercury</strong> <strong>Analyzer</strong><br />
Chapter 3: Installing the <strong>Analyzer</strong><br />
1 The tubing from the output of the pump to the rinse station intake port is preconnected<br />
at the factory.<br />
Figure 3-4<br />
Pump Output to Rinse Intake Port.<br />
2 Locate in the completion kit the 6 mm (¼") OD Tygon ® tubing. The tubing will<br />
need to be cut to the appropriate lengths.<br />
3 Cut a 38 cm (15") length of tubing. This will run between the drain port of the<br />
rinse station and the rinse input of the peristaltic pump.<br />
4 Connect one end to the input of the outer pump channel.<br />
The pump rotates counterclockwise, so the inputs are on the top and the<br />
outputs are on the bottom.<br />
Figure 3-5<br />
Pump Input Connection from Rinse Drain.<br />
27
Change language