CETAC M-7600 Mercury Analyzer Operator's Manual
CETAC M-7600 Mercury Analyzer Operator's Manual
CETAC M-7600 Mercury Analyzer Operator's Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>CETAC</strong> QuickTrace M-<strong>7600</strong> <strong>Mercury</strong> <strong>Analyzer</strong><br />
Chapter 3: Installing the <strong>Analyzer</strong><br />
The Z-drive is driven by a length of cable (line) which is made of solid Nylon<br />
101 (or in some cases, PEEK.)<br />
CAUTION<br />
Do not allow the cable to bend sharply. Avoid pushing up on the slider or pushing<br />
on the Z-drive cable.<br />
CAUTION<br />
Do not tighten the thumbscrews with anything other than your fingers.<br />
1 Locate the Z-drive assembly.<br />
Sleeve (Protects<br />
Z-Drive Cable)<br />
Sample Tube<br />
Z-Axis Slider<br />
Guide Block<br />
Y-Axis Slider<br />
Z-Drive Cable<br />
Sample Probe<br />
Home flag<br />
Figure 3-11 Z-Drive Assembly (Appearance May Vary Slightly Depending on<br />
Autosampler Model).<br />
2 Slide the Z-drive assembly onto the autosampler arm.<br />
Figure 3-12 Sliding the Z-Drive Onto the Arm of the Autosampler.<br />
31
Change language