272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf
272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf
272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Disassemble Carburetor<br />
1. Remove four screws (1) and float bowl (2),<br />
Fig. 130. Discard gasket.<br />
2. Use 13 mm thin profile wrench to remove fuel<br />
solenoid (3) from float bowl. Discard gasket.<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
Fig. 132<br />
Fig. 130<br />
3. Remove main jets (4) from float bowl, Fig. 131.<br />
This completes the carburetor disassembly<br />
procedure.<br />
<br />
Clean Carburetor<br />
1. Disassemble carburetor.<br />
2. Remove and discard all old gaskets, seals and<br />
sealing material.<br />
CAUTION<br />
Fig. 131<br />
4. Remove float hinge pin (18), float (5) and inlet<br />
needle (6) from carburetor body, Fig. 132.<br />
5. Remove limiter caps (8) and mixture adjustment<br />
screws (7).<br />
6. Remove screws (9) and choke plate (10).<br />
7. Remove choke shaft (13) and bushings (11, 12)<br />
from carburetor body.<br />
8. Mark throttle plates (15) before removal so they<br />
will be re-installed in the original position. Sides<br />
of throttle plate are beveled.<br />
9. Remove screws (9), throttle plates and throttle<br />
shaft (14) with bushings (16) and seal (17).<br />
Discard seal.<br />
AVOID INJURY!<br />
• Wear suitable protection when using cleaners.<br />
Follow instructions on container.<br />
3. Use a commercial carburetor cleaner such as<br />
Briggs & Stratton Spray Cleaner #100041 or<br />
#100042 to clean carburetor parts and body.<br />
NOTE: Parts containing rubber, such as seals,<br />
O-rings, inlet needles, seats or pump<br />
diaphragms should not be placed in<br />
commercial carburetor cleaner.<br />
Do not leave non-metallic parts (plastic,<br />
nylon, Minlon, etc.), in commercial<br />
carburetor cleaner more than 15 minutes.<br />
110