272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf
272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf
272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
21. Position bowl drain as shown.<br />
22. Torque screw or solenoid to 45 in. lbs. (5 Nm).<br />
<br />
<br />
<br />
<br />
Fig. 37<br />
18. Install idle jet (18), plug (19) and gasket (20),<br />
Fig. 38.<br />
Fig. 40<br />
<br />
<br />
<br />
<br />
<br />
<br />
Mikuni Carburetor<br />
Models 290700, 303700, 350700 (Before<br />
951001xx)<br />
Check Throttle, Choke Shaft and Body For Wear<br />
NOTE: The measurement in Step 1 is taken with the<br />
carburetor off of the intake manifold.<br />
Fig. 38<br />
19. Install idle mixture screw (21) and spring (22),<br />
Fig. 39.<br />
1. Lay carburetor on flat surface. Use a feeler<br />
gauge (1) to check throttle and choke shaft<br />
clearance as shown in Fig. 41.<br />
NOTE: DO NOT tighten screw. DO NOT install the<br />
limiter cap at this time.<br />
<br />
<br />
<br />
Fig. 41<br />
Throttle shaft and choke shaft clearance must not<br />
exceed 0.010” (0.25 mm).<br />
Fig. 39<br />
20. Install bowl gasket (24), float bowl (25), washer<br />
(26) and screw (27) or anti-afterfire solenoid<br />
(23), if equipped, Fig. 40.<br />
NOTE: The inspection in Step 2 is performed after<br />
the carburetor has been disassembled.<br />
2. Inspect throttle shaft and choke shaft for wear<br />
(2), Fig. 42.<br />
85