272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf

2. Assemble carburetor onto mounting studs,
Fig. 24.
Fig. 26
Fig. 24
3. Connect choke link (7) to choke lever and install
choke control bracket (5), single barrel
carburetor, Fig. 27, two barrel carburetor,
Fig. 28. Torque screws (6) to 65 in. lbs. (7 Nm).
All Models
1. Connect governor link (3) to throttle lever (1).
Snap retainer (2) over link, single barrel
carburetor, Fig. 25, two barrel carburetor,
Fig. 26.
2. Install governor link spring (4) in loop on retainer.
NOTE: If the carburetor is equipped with an antiafterfire
solenoid, route the wire under the
intake manifold and through the hole in #1
cylinder shield at this time.
Fig. 27
Fig. 25
Fig. 28
4. Install fuel line and clamp.
Horizontal Crankshaft
Models 290400, 303400, 350400
1. Assemble gaskets (1), spacer (3) and
carburetor to intake manifold, Fig. 29.
170