272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf

Remove Carburetor and Intake Manifold
Vertical Crankshaft, All Models
1. Remove air cleaner assembly.
2. Remove two screws (2) and choke control
bracket, Fig. 9.
2. Disconnect choke link (1) from carburetor.
3. Disconnect fuel line at carburetor.
4. Disconnect governor link and spring (4) from
retainer (3) and throttle lever (2).
5. Disconnect governor link.
3. Disconnect choke link (1) from carburetor.
NOTE: If engine is equipped with anti-afterfire
solenoid, air cleaner bracket (3) must be
removed BEFORE removing carburetor,
Fig. 9.
Fig. 11
6. Disconnect fuel line at carburetor.
7. Remove intake manifold and gaskets.
Fig. 9
4. Remove carburetor mounting screws (4) and
carburetor, Fig. 10.
Remove Control Bracket
1. Remove governor control bracket (1), Fig. 12.
2. Remove valley cover (2) and cylinder shields (3).
Fig. 10
Horizontal Crankshaft – All Models
NOTE: Disconnect anti-afterfire solenoid wire from
equipment switch wire. Remove blower
housing.
1. Remove two screws and choke control bracket
(5), Fig. 11.
Remove Armatures
Fig. 12
1. Disconnect stop switch wires at armatures.
2. Remove armature screws and lift off armatures
(1), Fig. 13.
70