272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf
272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf
272144 Vanguard Twin Cylinder OHV BRIGGS & STRATTON.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
NOTE: Do not use wire, drills or other mechanical<br />
devices to clean out metering holes or<br />
passages.<br />
Inspect Carburetor<br />
Inspect all parts for wear, cracks, nicks and burrs.<br />
Inspect float for leaks. Replace damaged parts.<br />
Assemble<br />
8. Install new throttle shaft welch plug. Use round<br />
punch and tap in plug until it is flat.<br />
9. Use sealant on outside diameter of welch plug to<br />
prevent leaks.<br />
10. Install new ‘‘E” ring (11), washer (10) and felt<br />
seal (9) onto choke shaft, Fig. 35.<br />
11. Insert spring (8) and check ball (7) in to spring<br />
pocket. Compress with a small round punch.<br />
When assembling carburetor, use new seals and<br />
gaskets.<br />
1. Install new transitional hole idle port welch plug<br />
(1), Fig. 33.<br />
2. Use a round punch (2). Tap in plug until it is flat.<br />
3. Seal the outside diameter of plug with<br />
Permatex ® #2 or nail polish to prevent air leaks.<br />
<br />
<br />
<br />
<br />
<br />
Fig. 35<br />
12. Install choke shaft.<br />
13. Install choke plate as shown, Fig. 35.<br />
NOTE: Use LOCTITE ® 222 on screw threads.<br />
14. Assemble inlet needle retainer (12) to inlet<br />
needle (13). Assemble to float, Fig. 36.<br />
15. Install float.<br />
Fig. 33<br />
4. Assemble new throttle shaft seal (4) with sealing<br />
lip out, Fig. 34.<br />
5. Install throttle shaft with collar (3).<br />
16. Install emulsion tube (15) and fixed main jet (14).<br />
<br />
<br />
6. Install washer (5) and snap ring (6).<br />
ÒÒ<br />
<br />
<br />
<br />
<br />
<br />
<br />
Fig. 36<br />
7. Install throttle plate.<br />
Fig. 34<br />
NOTE: Use LOCTITE ® 222 on screw threads.<br />
17. Check float adjustment, Fig. 37.<br />
a. Hold carburetor in vertical position with float<br />
hinge up as shown.<br />
b. Float should be parallel (17) to bowl<br />
mounting surface.<br />
c. Bend tang (16) if required.<br />
NOTE: DO NOT press on float to adjust.<br />
84