section 7 - Index of

JSET Jump If Bit Set JSETInstruction Format:JSET #n,S,xxxxOpcode:23 16 15 8700000101 D DDDDDloo 1bbbbbABSOLUTE ADDRESS EXTENSIONInstruction Fields:#n=bit number=bbbbb,S=source register=DDDDDD,xxxx=16-bit Absolute Address in extension wordSource Register4 registers in Data ALU8 accumulators in Data ALU8 address registers in AGU8 address offset registers in AGU8 address modifier registers in AGU8 program controller registersDDDDDDo 0 0 1 D D001 DDD010 TT To 1 1 N N N1 0 0 F F F1 1 1 G G GBit Number bbbbb00000•10111See Section A.1 0 and Table A-18 for specific register encodings.Notes: If A or B is specified as the destination operand, the following sequence of eventstakes place:1. The S bit is computed according to its definition (See Section A.5)2. The accumulator value is scaled according to the scaling mode bits SOand 81 in the status register (SR).3. If the accumulator extension is in use, the output of the shifter is limited tothe maximum positive or negative saturation constant, and the L bit is set.4. The bit test is performed on the resulting 24-bit value, and the jump is takenif the bit tested is set. The original contents of A or B are not changed.Timing: 6+jx oscillator clock cyclesMemory: 2 program words