Admin Guide - Mizu Voip

The billed user will be the logged in user. The p2p command has 3 parameters. A number, B number and IVR id (optional).2 CDR records are generated for these calls, both of them billed to the initiator (based on your usual pricing).The call to the A number will be initiated from “callbackcallernumber” configurable number or from the user who initiated the call.You must set the “checkdbconf” global config value to 1 or 2 if you need to initiate phone 2 phone calls from the database (initiated from website forexample)4.11.19. Virtual ServersYou can create up to 100 virtual servers on a single pc. These are completely separate billing/routing/signaling entities and can be used for differentbusiness models or to offer hosted services to separate companies or organizations.If you can afford, use a specific number prefix for each virtual server and setup the routing on the main server accordingly.If a specific number scheme cannot be used:On the main server you can specify to wich virtual server a number belongs in the “numbers” table (MManage -> Other -> Phone Numbers). In thelocation field, the virtual server sipuser id must be entered. -1 means that the number belongs to the main server.Make sure that each service will use a different IP (bind ip) or the ports are set to be different.4.11.20. Other featuresThe Mizu VoIP server implements most of the SIP related RFC’s as described here.4.12. Additional modulesThe following modules can be enabled optionally and are part of the “all-in-one” package:4.12.1. Calling-CardThe calling card functionality is implemented by using the IVR module described in the previous section4.12.2. SMSSMS messages can be sent by connecting to the console port or by simple chat message (mobile phones can be checked and converted to SMS instead ofIM)Incoming SMS requests can be converted to http get requests and forwarded to an sms gateway defined by the smsurl global config value. In the smsurl youcan use the following keywords: fromid, fromnum,message,smsid.