Admin Guide - Mizu Voip

11: isdngw, (parentid is the gatewayowner)12: sms, fax,email gateway14: support users (can operate with MManage, has ftp account)15: admin users (can see and modify everything, can receive email/sms reports)17: other users (for various reasons)ParentID:This field is very important for resellers/subresellers relationships.Logical parent of the user. Checked for routing pattern, max lines, etc.if a sipenduser then reseller companyif traffic sender, then traffic ownerif gateway, then gateway ownerif reseller company, than operatorBillingUserID:Where the invoices will be sent. Credit will checked for these usersIf the current type is an end-user, then can have a BillingUserID where we send the invoices. If not set or the same ID as the current, than the bills will be generated titself. For example in a company, all bills will be sent to the boss (company address), nit the employeeIsBilledUser: set to 1 if this user is not a real service user, but a user who pays for other user. Usually this is a company who pays for its employee.Deprecated!UserGroup: users can call each other only if the user group is the same (default: 0)usually users with the same parentid (reseller) has common parentidRingGroup: a list of usernames separated by comma (all number will ring when the actual user will be called)BelongsToCompany: when a company has more then one subscriber. Used for example for short sip numbers.IsCompany: if the current user actually is a companyRGMode: how to use the ringgroup: 0=forked call, 1=round robinName: user first and last –nameCountry: sip phone country (important for prefix rules)ContactName: additional nameUseCallingCard: if has calling card (usable with pin codes)CanDial: example: for sipuser is 1. for simowners is 0Phone: user phone number (but not the sip phone)Email: where the user can be contactedAddress: where the user can be contactedBilladdress: where to send the invoicesTelNumber: sip telnumber.users can be contacted if we call there username or telnumber.More than one DID or ANI number can be assigned for one user. For this the tb_users_othernumbers table is used where the type field is 0 for DID numbers and 1 fornumbers.