Admin Guide - Mizu Voip

Postpaid: if the user will prepaid or postpaidPaymentMode: Check (0), Bank Tranfer (1), Cash (2), Else (3)ContractNumber: contract for end-usersAllowedpartners:Allowed traffic senders for the gateway, or allowed gateways for traffic senders.A list of user id separated by comma or ‘*’Note that parent users will be checked tooEnabledprefixes: can be one prefix (with any length) or a list of prefixes with 3,4 or 5 digit separated by comma.Can be used for trafic senders and gateways too. No need to setup a separate routing pattern if you use this restriction.EnabledTechPrefixes: enabled techprefixes for the specified gateway (3 digit length numbers separated by comma)BlockPrefixes: list of called prefixes that will be blocked for the user (techprefix will not be considered here). Numbers listed here must have 7 digitlength and separated with comma.ContractState: the status of the contract0- Unknown1- Not applicable2 -In Progress3 -Active4 -TerminatedContractComment: additional comment for salesCredit: when postpaid, then we also can set a max amount (which will reset in every month)Enabled: if disabled, it behaves as if it were deletedDomainName: sipproxy domain namePort: signaling portTransIp: secondary signaling ipTransPort: secondary signaling portRouteRtpCaller: routing mode if this endpoint is the caller0=check called settings –this is the preferred settings1=don't touch the sdp and the rtp2=sdp correction if necessary3=route rtp if both behind nat4= route rtp if caller is behind nat5= route rtp if called is behind nat6= route rtp if any endpoint is behind nat7=always route rtpRouteRtpCalled: routing mode if this endpoint is the called0=check caller settings1=don't touch the sdp and the rtp2=sdp correction if necessary –this is the preferred settings