Admin Guide - Mizu Voip

5.4. How can I make test calls?1. simply right click on a channel (“Simcards” form) and select the “Test call” option2. or use one of the voip clients from the “Tools” menu5.5. How to check the call quality on a specific channel?1. In the “Set Directions” box set the preffered simid. Then go to the “Statistics” form and check the ASR/ACD values.2. Start some tescalls (right click on the preferred channel and then hit the “Test Call” menu)3. Listen to conversation. (“Voice Here” form)5.6. Typical Cisco Config! dial-peer voice 3630 pots incoming called-number 0040T direct-inward-dial port 2:D ! dial-peer voice 3631 voip destination-pattern 0036 voice-class codec 1 voice-clh323 1 session target ipv4: 1.2.3.45.7. Server Recovery (in a separate app and db server configuration)if the application server fails (the server directly connected to the internet, with your public ip1. call your ISP support to change the internet cable to the backup server, and when it will be available connect to the "backupserver" with the remote desktop"root" account-on the backup server do the following:2. enable the "mserver" service3. launch the start batch file (from gk directory)4. check the vservdebuglog and the MManageif the backup server fails (the server behind the main server, with private ip)-connect to the main server with the remote desktop "root" account-On the main server, do the followings:1. launch the stop batch file (from the gk directory)2. Enable and Start the SQLSERVER service3. Restore latest database4. launch the start batch file5. check the vservdebuglog and MManage (you must have current calls)6. you are ready5.8. No incoming calls (no new calls in current call list in peak time)1. Check the logs (filtered to „Server”)2. If you cannot find the solution then.