Admin Guide - Mizu Voip

The defined commission percent will be calculated for the profit or for the enduserprice. This behavior can be set by the “salescomissionfromprofit” globalconfig.Sales can give up for the users some reduction wich will be substracted from their cost. This can be configured with the “reduction” value for the individualendusers.5.74. Multihomed setupUDP ports must be binded to different ip interface (at least the default sip port 5060), or set to different values.TCP ports must be setup differentlyOn the gsm gateway set the serverip to the binded ip and the cmdport to the gsmclientportChange the pipename setting in the gatekeeper.ini5.75. How to scan your SP for live numbersThe scanner thread can be used to initiate phone calls to a range of phone numbers and will store the validity status of these number in CDRrecords.Phone numbers can be specified by a range (scan_from, scan_untill) or loaded from a text file (scan_filepath).The speed of the thread can be controlled by the following options: scan_callival, scan_callsperminute, scan_maxcalls (you might specify all these 3constrains for a better control).If there is no error in the configuration, the scanner thread will start immediately withing 2 minutes after service startup.Otherwise the scanner can be started/stopped with the “checkscanner” console command (will start if the parameters are ok and scan_enableThe following global config values must be set accordingly:scan_enable –set to 0 to disable scanning or 1 to enable (The scanner thread will start automatically if this is set to 1 and will stop automatically on 0 value)scan_from –range startscan_untill –range endscan_filepath-to load the numbers from filescan_callernum –a valid username (phone number) from “users and devices”. Proper routing must be set for this caller. (A number)scan_callival –new call attempt interval in msec. (delay between 2 calls)scan_callsperminute –max calls/minute to initiatescan_maxcalls –max simoultan callsscan_stop_at –at what stage the call setup progress will stop.0=trying,1=progress (default),2=ringing,3=connect*all global config can be listed if you filter for the “scan” word”The results can be seen in the marker field of the cdr records: