Admin Guide - Mizu Voip

3= route rtp if both behind nat4= route rtp if caller is behind nat5= route rtp if called is behind nat6= route rtp if any endpoint is behind nat7=always route rtpRtp settings will be checked first for the called and then the caller (so if the caller RouteRtpCaller settings is not 0, then it will overwrite the called RouteRtpCalledsettings)RtpIp: last rtp ipRtpPort: last rtp portServerRtpPort: last bind (we try to use the same for every user)NatDetected: 0= no and don’t change, 1=no but can be changed, 2=yes but can be changed, 3 yes, and don’t change itNatDetectDisabled: deprecatedStatus: 0=inactive,1=registered, 2=speaking (if statusdate is too old, then treat as 0)StatusDate: last status changeCalledNumber: last called numberCalledID: last called idDiscount1: discount percent. users can have discounts in for max 3 directionsDirection1: prefix. users can have discounts in for max 3 directionsDiscount2: discount percent. users can have discounts in for max 3 directionsDirection2: prefix. users can have discounts in for max 3 directionsDiscount3: discount percent. users can have discounts in for max 3 directionsDirection3: prefix. users can have discounts in for max 3 directionsTechPrefix:The server can authorize and/or route the traffic after the incoming techprefix.Sip users can have techprefixes too. this is usually common for reseller company users.If no techprefix is specified, then it will be loaded from tb_pxrules if any.Sim owners and vpc users can have a list of prefixes separated by comma.If no techprefix is specified, 111 will be inserted for incoming called numbers.If the techprefix is „-1”, then the original techprefix will be forwarded.If the techprefix is „-2”, then the original techprefix will be inserted in cdr record (but not forwarded).If the techprefix is empty, then only the normalized callednumber will be forwarded.The following techprefixes are reserved for the server: 111,222,999.Only 3 digit techprefix is allowed. If your traffic sender needs another techprefix length, you must rewrite the incoming number in the “Prefix Rules” form.Example: protcoll: sip, Type: ip, value: your traffic sender ip, rewritefrom: oldtechprefix, rewriteto: newtechprefix.Addtechprefix: we insert this number before the callednumber if the caller don’t send its calls with tech prefixMaxLines: max concurrent calls allowedmaxlinetouse: deprecated