Admin Guide - Mizu Voip

SU1=unknownSS1=trying (scan success 1: the last status was: trying) -2SS2=progress (scan success 2: the last status was: progress) -3SS3=ringing (scan success 3: the last status was: ringing) -4SS4=connect (scan success 4: the last status was: connect) -5SF1=disc code (scan failed 1: the last status was: disc code received) -6SF2=bye (scan failed 2: the last status was: bye received) -7For example the following query will list all live numbers when the scan_stop_at is set to 1:select callednumber from tb_cdrs with(nolock) where datum > X and callerid = Y and marker in ('SS2', 'SS3','SS4')You might also consider a number to be live on special disconnect reason codes (like user busy)Disconnect codes are stored in tb_reasoncodes (there are mappings to SIP codes)For example the following statement will list all numbers found as valid in the last 7 days including calls with “Busy here” disc reason.select callednumber from tb_cdrs with(nolock) where datum > GETDATE() - 7 and (marker in ('SS2', 'SS3','SS4') or(marker = 'SF1' and discreason in (4486)))5.76. Routing calls from virtual serversThe actual virtsever must be configured as a traffic-sender in the mainserver.In the virtserver, the mainserver must be configured as a sip-proxy.Setup the routing in the virtual server and in the mainserver too.5.77. Routing calls to virtual serversFrom the mainserver there are two possibilities:-set some phone numbers “location” to virtserver id and /or-setup the routing (for a range of numbers defined by a prefix)The actual virtsever must be configured as a sip-proxy in the mainserver.In the virtserver:-setup the callbacknumber ant it’s routing correctly in global configuration and /or-assign real phonenumbers for operators (or endusers)In the virtserver, the mainserver must be configured as a traffic-sender..5.78. How to add plugins in MManageCreate your custom exe.In the MizuManage.ini under the “plugins” section add your plugin entry: