MPLAB ICD 3 In-Circuit Debugger User's Guide

MPLAB ® ICD 3 In-Circuit Debugger User’s GuideTrigger OutputTrigger output refers to an debugger output signal that can be generated at anyaddress or address range, and is independent of the trace and breakpoint settings. Anynumber of trigger output points can be set.Uninitialized DataData which is defined without an initial value. In C,int myVar;defines a variable which will reside in an uninitialized data section.UploadThe Upload function transfers data from a tool, such as an debugger or programmer,to the host PC or from the target board to the debugger.USBUniversal Serial Bus. An external peripheral interface standard for communicationbetween a computer and external peripherals over a cable using bi-serial transmission.USB 1.0/1.1 supports data transfer rates of 12 Mbps. Also referred to as high-speedUSB, USB 2.0 supports data rates up to 480 Mbps.WarningAn alert that is provided to warn you of a situation that would cause physical damageto a device, software file, or equipment.Watch VariableA variable that you may monitor during a debugging session in a Watch window.Watch WindowWatch windows contain a list of watch variables that are updated at each breakpoint.Watchdog TimerA timer on a PIC microcontroller that resets the processor after a selectable length oftime. The WDT is enabled or disabled and set up using Configuration bits.WDTSee Watchdog Timer.WorkbookFor MPLAB SIM stimulator, a setup for generation of SCL stimulus.WorkSpaceA workspace contains MPLAB IDE information on the selected device, selected debugtool and/or programmer, open windows and their location, and other IDE configurationsettings.DS51766A-page 98© 2008 Microchip Technology Inc.