MPLAB ICD 3 In-Circuit Debugger User's Guide

MPLAB ® ICD 3 IN-CIRCUITDEBUGGER USER’S GUIDEChapter 10. Hardware Specification10.1 INTRODUCTION10.2 HIGHLIGHTSThe hardware and electrical specifications of the MPLAB ICD 3 in-circuit debuggersystem are detailed.This chapter discusses:• Declaration of Conformity• USB Port/Power• MPLAB ICD 3 Debugger• Standard Communication Hardware• ICD 3 Test Interface Board• Target Board Considerations10.3 DECLARATION OF CONFORMITYWeMicrochip Technology, Inc.2355 W. Chandler Blvd.Chandler, Arizona 85224-6199USAhereby declare that the product:MPLAB ® ICD 3 In-Circuit Debuggercomplies with the following standards, provided that the restrictions stated in theoperating manual are observed:Standards: EN61010-1 Laboratory EquipmentMicrochip Technology, Inc.Date: August 2006Important Information Concerning the Use of the MPLAB ICD 3 In-Circuit DebuggerDue to the special nature of the MPLAB ICD 3 in-circuit debugger, the user is advisedthat it can generate higher than normal levels of electromagnetic radiation which caninterfere with the operation of all kinds of radio and other equipment.To comply with the European Approval Regulations therefore, the following restrictionsmust be observed:1. The development system must be used only in an industrial (or comparable)area.2. The system must not be operated within 20 meters of any equipment which maybe affected by such emissions (radio receivers, TVs etc.).© 2008 Microchip Technology Inc. DS51766A-page 79