MPLAB ICD 3 In-Circuit Debugger User's Guide

MPLAB ® ICD 3 In-Circuit Debugger User’s Guide9.5.3 Settings Dialog, Freeze on Halt TabSelect peripherals to freeze on halt on this tab.PIC18 MCU DevicesTo freeze/unfreeze all device peripherals on halt, check/uncheck the “Freeze on Halt”checkbox. If this does not halt your desired peripheral, be aware that some peripheralshave no freeze on halt capability and cannot be controlled by the debugger.dsPIC30F/33F, PIC24F/H and PIC32MX DevicesFor peripherals in the list “Peripherals to Freeze on Halt”, check to freeze that peripheralon a halt. Uncheck the peripheral to let it run while the program is halted. If you donot see a peripheral on the list, check “All Other Peripherals”. If this does not halt yourdesired peripheral, be aware that some peripherals have no freeze on halt capabilityand cannot be controlled by the debugger.To select all peripherals, including “All Other Peripherals”, click Check All. To deselectall peripherals, including “All Other Peripherals”, click Uncheck All.9.5.4 Settings Dialog, Status TabView the status of your MPLAB ICD 3 system on this tab.TABLE 9-8: STATUS ITEMSVersionsFirmware Suite Version Debugger firmware suite version. The firmware suite consists ofthe three items specified below.FPGA VersionInternal FPGA chip firmware version.Algorithm Plug-in Version Debugger algorithm plug-in version. For your selected device, analgorithm is used to support the device plugged into the target.OS VersionDebugger operating system version.VoltagesICD 3 VPPDebugger VPP.ICD 3 VDDDebugger VDD.Target VDDVDD sensed at target.Refresh Voltages Sensing of Status tab items occurs when the tab is achieved. Tosee updates otherwise, click this button.DS51766A-page 76© 2008 Microchip Technology Inc.