AED 10 User Manual - Welch Allyn

70 Troubleshooting Welch Allyn AED 10 Automated External DefibrillatorAnalyzing interruptedIndicator/Possible CauseDefibrillator pad removed.Electrical interference or radio transmissions.Electrical/radio frequency interference.Corrective ActionPress defibrillation pad to firmly attach it to patient's skin.If needed, replace the pad.Remove possible sources of electrical or radiointerference.Move hand-held communication devices or othersuspected devices away from the AED 10.Defibrillation pads disconnected from patient or AED 10. Check the connection to the AED 10.Patient movement.Patient’s motion (CPR, seizures, etc.)Transportation of the patient during vehicle motion.Move patient to stable location when possible.Stop patient motion if possible.Stop patient movement or, if possible, stop vehicletransportation during analysis.No shock deliveredIndicator/Possible CauseDefibrillation pad connector not properly connected to theWelch Allyn AED 10 socket.Improper pad placement or pads touching each other.Pads, cable, or connector damaged.Poor defibrillation pad contact with patient’s bare chest.Shock button not pressed within fixed time limit.Corrective ActionPush pads connector firmly into Welch Allyn AED 10connector socket.Check pad placement. Use the pictures on the pads tomake sure they are in correct location.Replace pads.Press pads firmly to patient’s bare chest.Wipe moisture from chest and/or shave excessive hairfrom chest.Replace the pad, if needed.Press Shock button within 30 seconds (Automated Mode)or 60 seconds (Manual Mode) after the ready message.Defibrillation pads disconnected from patient or AED 10. Check the connection to the AED 10.