Model 7002Switch System Instruction Manual - Advanced Test ...

IEEE-488 ReferenceTable 5-4IEEE-488.2 common commands and queriesMnemonic Name Description Para.*CLS Clear status Clears all event registers, and Error Queue. 5.10.1*ESE Event statusenable commandSets the contents of the Standard Event Status Enable Register.5.10.2*ESE? Event status enable query Request the programmed value of the Standard Event StatusEnable Register.5.10.3*ESR?Event statusregister queryRequest the programmed value of the Standard Event StatusRegister and clears it.5.10.4*IDN? Identification query Request the manufacturer, model number, serial number,and firmware revision levels of the unit.5.10.5*OPCOperation completecommandSets the Operation Complete bit in the Standard Event StatusRegister after all pending commands have been executed.5.10.6*OPC? Operation complete query Places an ASCII “1” into the output queue when all pendingselected device operations have been completed.5.10.7*OPT? Option identification query Request the assigned model number for all slots. 5.10.8*RCL Recall command Returns the Model 7002 to the setup configuration stored inthe designated memory location.5.10.9*RST Reset command Returns the Model 7002 to the *RST default conditions. 5.10.10*SAV Save command Saves the current setup configuration to the designatedmemory location.5.10.11*SRE Service requestenable commandSets the contents of the Service Request Enable Register. 5.10.12*SRE?Service requestenable queryThe Model 7002 returns the value of the Service RequestEnable Register.5.10.13*STB? Read status byte query Returns the value of the Status Byte Register. 5.10.14*TRG Trigger command This command issues a bus trigger which has the sameeffect as group execute trigger (GET) command.*TST? Self-test query When this query is sent, the Model 7002 will perform achecksum test on ROM and return the results.5.10.155.10.16*WAIWait-to-continuecommandWait until all previous commands are executed. 5.10.17Note: At least one space is required between the command and the parameter.5-42