Model 7002Switch System Instruction Manual - Advanced Test ...

Trigger subsystemIEEE-488 Reference5.18.8 :SIGNal:ARM[:SEQuence[1]][:LAYer[1]]:SIGNal:ARM[:SEQuence[1]]:LAYer2:SIGNal:TRIGger[:SEQuence[1]]:SIGNalBypass arm control sourceBypass scan control sourceBypass channel control sourceShort-formformatDescription:arm:signThese action commands are used to bypass the specified control source and are used when youdo not wish to wait for the programmed event. Keep in mind that the instrument must be waitingfor the appropriate event when the command is sent. Otherwise, an error will occur and thiscommand will be ignored.When this command is sent, the specified control source will be bypassed. This will allow operationto continue. Only the layer’s source event between is bypassed; any :DELay time willbe observed.Note that :SIGNal is not an instrument setup command. As soon as this command is executed,it will attempt to bypass the control source.ProgrammingexampleOUTPUT 707; “:trig:sign”! Bypass channel control source.5.18.9TCONfigure commands:PROTocol :TRIGger[:SEQuence[1]]:TCONfigure:PROTocol Specify Trigger Link protocolParameters = ASYNchronous Asynchronous Trigger Link mode= SSYNchronous Semi-synchronous Trigger Link modeShort-formformat:trig:tcon:prot DefaultsPower-up*RST:SYSTem:PRESetSaved power-on setupASYNchronousASYNchronousQuerycommands:PROTocol?Short-form format:Response message:Query programmed Trigger Link protocol:trig:tcon:prot?ASYN or SSYN5-141