Model 7002Switch System Instruction Manual - Advanced Test ...

Front Panel Operation(on power-up) Model 701X series cards that are installed. Allother type cards are not detected and thus, the slot must beassigned the appropriate model number by the user. This userassigned model number is “remembered” by the mainframeafter it is turned off. However, if the mainframe detects a701X series card in the slot on the subsequent power-up, itdisregards the model number assigned by the user and assignsthe model number of the 701X series card to the slot.You can use Table 4-6 to interpret the displayed messages forTYPE.Each used slot must be assigned the correct model number(either automatically by the mainframe for 701X series cardsor manually by the user) in order for the mainframe to operatecorrectly. The model number assignment automaticallydetermines the settling time for the relays.Changing a slot assignment (Card TYPE) could make achannel that is currently included in the Scan List and/or aChannel Pattern unavailable. The unavailable channel causesthe Scan List and/or the affected Channel Pattern to clear(see paragraphs 4.8 and 4.11 for details).Table 4-6TYPE assignmentsAssignment message Interpretation*SLOT CARD: 701X** 701X series cardinstalled in specified slot.SLOT CARD: NONE No card installed in slot,or specified slot is notassigned.SLOT CARD: 7YYY*** Non-701X series modelnumber assigned to specifiedslot by the user. Thecard may or may not beinstalled in the slot. Also,a different non-701Xseries card may beinstalled.SLOT CARD: 9990 Specified slot assignedby user to simulate a 40-channel multiplexer. Anon-701X card may beinstalled.Table 4-6 (continued)TYPE assignmentsAssignment messagePerform the following steps to assign card TYPE to a slot.1. Press the CARD CONFIGURATION key to display theCARD CONFIG MENU.2. Place the cursor on TYPE and press ENTER to selectSET CARD TYPE. The card type for the currently selectedslot will be displayed. For example:SET CARD TYPE NONESLOT-#1 #2 #3 #4 #5Interpretation*SLOT CARD: 9991 Specified slot assignedby user to simulate a 4 ×10 matrix. A non-701Xcard may be installed.* Assumes that power is cycled whenever a card is installed orremoved from the mainframe.** Model 701X series card, such as the Model 7011, 7012, 7013 or7014.*** Models 7052 though 7402.In the above example, #3 flashes to indicate that slot 3 isassigned to be empty (NONE). To check card assignmenttypes for the other slots, simply use the cursor keys( and ) to place the cursor on the slot number.3. Determine the correct assignment for the slot using thefollowing guidelines:a. If the slot is empty and is not going to be used, assignit as “NONE”. This will turn off the front panelchannel LEDs for the slot since it is not going to beused.b. If using a non-701X series card (Models 7052through 7402) that is installed in the slot, assign theslot as that model number. For example, if the Model7062 is installed in slot 1, assign slot 1 as “7062”.c. If the slot is going to be used to simulate a 40-channelmux, assign it as “9990”. To simulate a 4 × 10matrix, assign it as “9991”. Note that a non-701Xseries card left installed will be controlled while usingthe slot as a simulator.4. Perform the following steps to change the card type assignmentfor a slot:a. Place the cursor on the desired slot number andpress ENTER. For example:SLOT 5 CARD: NONE4-38