Model 7002Switch System Instruction Manual - Advanced Test ...

[:ROUTe] subsystemIEEE-488 ReferenceShort-formformats:mem:save:list , MDefaultsPower-up*RST:SYSTem PRESetNo effectNo effectNo effectDescriptionThis command is used to define and save (store) a channel pattern at a memory location. The parameter specifies the memory location for the channel pattern. The parameterdefines the channel pattern. When the channel pattern is recalled or scanned, the channels listedin the chanlist will close. The following examples demonstrate various forms for expressingchannel entries for a chanlist.Chanlist1!2!4 Single channel (Slot 1, Row 2, Column 4).2!36 Single channel (Slot 2, Channel 36).1!6, 1!18, 2!3!6 Multiple channels separated by commas.1!2:1!10 Range of channels (2 through 10).1!2:1!10, 2!3!6 Range entry and single entry separated by commas.1!30:1!40, 2!1:2!10 Range of multiplex channels (last 10 channels on card 1,first 10 channels on card 2).1!4!1:1!4!10, 2!1!1:2!1!10 Range of matrix channels (10 columns of row 4 on card1, 10 columns of row 1 on card 2).Up to 500 channel patterns can be saved in memory locations 1 to 500. A channel pattern canbe recalled from memory using the :RECall command.Note: An alternate method to save a channel pattern is to use the :SAVE:[RELays] command.With this method, you close the desired channels and then save that channel pattern at a memorylocation.A Channel Pattern is not lost (cleared) after the instrument is turned off. However, a ChannelPattern is cleared if a closed channel in the pattern becomes unavailable, restricted or interlockedto another channel in the pattern.ProgrammingexampleOUTPUT 707; “:mem:save:list (@ 1!1:1!10), M24”Saves defined channel list (ch 1-10, Slot 1) to memory location 24.5-97