Model 7002Switch System Instruction Manual - Advanced Test ...

IEEE-488 Reference5.15 :SOURce subsystemThis subsystem is used to set the logic level (true or false) of each digital output line. The commands for this subsystem aresummarized in Table 5-10.Table 5-10SOURce command summaryCommand:SOURce:TTL[1][:LEVel] [:LEVel]?:TTL2[:LEVel] [:LEVel]?:TTL3[:LEVel] [:LEVel]?:TTL4[:LEVel] [:LEVel]?DescriptionDigital output line #1.Set line true (1 or ON) or false (0 or OFF)Query state of digital output line.Digital output line #2.Set line true (1 or ON) or false (0 or OFF)Query state of digital output line.Digital output line #3.Set line true (1 or ON) or false (0 or OFF)Query state of digital output line.Digital output line #4.Set line true (1 or ON) or false (0 or OFF)Query state of digital output line.Notes:1. Brackets ([ ]) are used to denote optional character sets. These optional characters do not have to be included in the programmessage. Do not use brackets ([ ]) in the program message.2. Angle brackets (< >) are used to indicate parameter type. Do not use angle brackets (< >) in the program message.3. Upper case characters indicate the short-form version for each command word.4. At least one space is required between a command word and the parameter.[:LEVel] :SOURce:TTL[1]:[LEVel] Control digital output line #1:SOURce:TTL2:[LEVel] Control digital output line #2:SOURce:TTL3:[LEVel] Control digital output line #3:SOURce:TTL4:[LEVel] Control digital output line #4Parameters = 1 or ON Set output line true= 0 or OFF Set output line falseShort-formformats:sour:ttl :sour:ttl2 :sour:ttl3 :sour:ttl4 DefaultsPower-up*RST:SYSTem:PRESetOFF (all lines)No effectNo effect5-101