Model 7002Switch System Instruction Manual - Advanced Test ...

Getting Started■ Light pen methoda. Click channel 6 of slot 9.SELECT CHANNELS 9!2, 9!4, 9!6,b. Click the “–” LED. Note that the slot for the nextchannel is automatically entered.SELECT CHANNELS 9!2, 9!4, 9!6-9!c. Click channel 10 of slot 9.SELECT CHANNELS 9!2, 9!4, 9!6-9!10,b. Press OPEN (or OPEN ALL) to open the channelsspecified in the channel list. Note that OPEN ALLalso opens channels not specified in the list.■ Light pen methoda. Click CLOSE to close the channels specified in thechannel list.b. Click OPEN (or OPEN ALL) to open the channelsspecified in the channel list. Note that OPEN ALLalso opens channels not specified in the list.Step 2. Close and Open ChannelsPerform the following steps to close the channels specified inthe channel list:1. Select the relay status display mode:The instrument must be in the RELAY STATUS displaymode in order to view the open and closed channels onthe LED display. If the RELAY STATUS display modeis not currently selected, perform the following:■ Keypad methodParagraph 3.4.1 explains how to change the displaymode.■ Light pen methodRELAY STATUSSHOW LIST toggles between the two display modes.To change the display mode, click SHOW LIST.RELAY STATUS2. Close and open channels:■ Keypad method3.7.3 Scan channelsThe following procedures assume that the initial configurationprocedures in paragraph 3.7.1 has been performed. Thisinitiation will assign the 40-channel multiplexer simulator toslot 9.Create scan listPerform the following steps to create a scan list that includeschannels 1 through 20 of slot 9.1. If desired, select the list display mode:A scan list can be created while in the relay status displaymode. However, if you want channel LED status tocorrespond to the channels contained in the channel list,then place the instrument in the list display mode as follows:■ Keypad methodParagraph 3.4.1 explains how to change the displaymode.■ Light pen methodThe SHOW LIST LED toggles between the two displaymodes. To change the display mode, click SHOW LIST.a. Press CLOSE to close the channels specified in thechannel list.3-10