Model 7002Switch System Instruction Manual - Advanced Test ...

Front Panel Operation4.14 Scan configurationVarious operations to configure a scan are performed fromthe CONFIGURE SCAN menu. The menu structure isshown and summarized in Table 4-7.General rules to use CONFIGURE SCAN:1. The CONFIGURE SCAN menu is displayed by pressingthe SCAN CONFIGURATION key. The CONFIG-URE SCAN menu selections are shown as follows:CONFIGURE SCANCHAN-CONTROL SCAN-CONTROLARM-CONTROL CHAN-RESTRICTIONS2. The EXIT key causes the display to back up to the previousmenu level. Also, keyed-in parameter changes areignored if an EXIT is performed. When the CONFIG-URE SCAN menu is displayed, pressing EXIT will disableSCAN CONFIGURATION.3. The position of the cursor is denoted by the blinkingmenu selection or parameter. The cursor is moved fromone item to the next using the cursor keys ( and ).4. A displayed arrow ( or ) indicates that there ismore information or additional menu items to selectfrom. When “ ” is displayed, use the cursor key todisplay the additional message(s), and conversely, when“ ” is displayed, use the cursor key.5. A numeric parameter is keyed in by placing the cursoron the digit to be changed, and pressing the appropriatekey on the keypad. After keying in a number, the cursorwill move to the next digit to the right.6. A parameter change is only executed when the ENTERkey is pressed.7. ENTERing an invalid parameter generates an error andignores the entry.8. The INFO key can be used anywhere in the menu structureto display helpful information messages concerningoperation. To cancel an information message, pressEXIT or INFO a second time.9. The ENTER, EXIT, and keys have LED counterparts.Thus, with the optional light pen, you can clickthese LEDs instead of pressing the keys.4-41