Model 7002Switch System Instruction Manual - Advanced Test ...

[:ROUTe] subsystemIEEE-488 ReferenceDescriptionShort-form formats: :conf:slot:stim? :conf:slot:stim? xxx:conf:slot2:stim? :conf:slot2:stim? xxx:conf:slot3:stim? :conf:slot3:stim? xxx:conf:slot4:stim? :conf:slot4:stim? xxx:conf:slot5:stim? :conf:slot5:stim? xxx:conf:slot6:stim? :conf:slot6:stim? xxx:conf:slot7:stim? :conf:slot7:stim? xxx:conf:slot8:stim? :conf:slot8:stim? xxx:conf:slot9:stim? :conf:slot9:stim? xxx:conf:slot10:stim? :conf:slot10:stim? xxxwhere; xxx = def, min or maxResponse message: 0 to 99999.999An internally set relay settling time is provided to allow for switch bounce when it closes. Atpower-up, a settling time is automatically set based on the acquired identification informationfrom the card. The :STIMe command allows you to increase the delay for each slot.The delay value can be entered using the exponent form. For example, instead of sending a parametervalue of 2000 (seconds), you can instead send 2E3. To cancel this delay, send this commandusing a parameter value of 0.For complete information on this delay, see DELAY in Section 4.Programmingexample10 OUTPUT 707; “:conf:slot1:stim 10; stim?”20 ENTER 707; A$30 PRINT A$40 ENDLine 10 Sets a 10 second delay for Slot 1 and then queries the delay period.Line 20 Addresses the 7002 to talk.Line 30 Displays the delay period (10).5-95