Model 7002Switch System Instruction Manual - Advanced Test ...

Front Panel OperationPlace the cursor on BREAK-BEFORE-MAKE and pressENTER to display the following selections:BREAK BEFORE MAKEON OFFCursor position indicates the current state of Break-Before-Make.Place the cursor on the desired state and press ENTER. Theinstrument will return to the GENERAL MENU.NOTEWhen finished with the GENERALMENU, use EXIT to back out of the menustructure.4.13 Card configurationVarious operations to configure the slots of the mainframeare performed from the CARD CONFIG MENU. The menustructure is shown and summarized in Table 4-5.Table 4-5CARD CONFIG MENU structureMenu itemTYPESLOT#-OF-POLESSLOTCARD-PAIRDELAYSLOTREAD-I/O-CARDDescriptionSet Card Type:Assign model number to cardin specified slot.Select # Of Poles:Select pole mode for card inspecified slot.Enable or disable Card Pair.Set Delay For:Set delay for card in specifiedslot.Identify I/O Cards.General rules to use CARD CONFIG MENU:1. The CARD CONFIG MENU is displayed by pressingthe CARD CONFIGURATION key. The CARD CON-FIG MENU selections are shown as follows:CARD CONFIG MENUTYPE #-OF-POLES CARD-PAIRDELAY READ-I/O-CARD2. The EXIT key causes the display to back up to the previousmenu level. Also, keyed-in parameter changes areignored if an EXIT is performed. When the CARDCONFIG MENU is displayed, pressing EXIT will disablecard configuration.3. The position of the cursor is denoted by the blinkingmenu selection or parameter. The cursor is moved fromone item to the next using the cursor keys ( and ).4. A displayed arrow ( or ) indicates that there ismore information or additional menu items to selectfrom. When “ ” is displayed, use the cursor key todisplay the additional message(s); and conversely, when“ ” is displayed, use the cursor key.5. A numeric parameter is keyed in by placing the cursoron the digit to be changed, and pressing the appropriatekey on the keypad. After keying in a number, the cursorwill move to the next digit to the right.6. A parameter change is only executed when the ENTERkey is pressed.7. ENTERing an invalid parameter generates an error andignores the entry.8. The INFO key can be used anywhere in the menu structureto display helpful information messages concerningoperation. To cancel an information message, pressEXIT or INFO a second time.9. The ENTER, EXIT, and keys have LED counterparts.Thus, with the use of the optional light pen,these LEDs can be used instead of the keys.4.13.1 TYPEUse TYPE to assign a model number to each non-701X seriescard installed in the mainframe. This menu selection alsoallows you to assign a slot to operate as a simulator. By assigninga slot the value 9990, the mainframe will operate asif a 40-channel multiplexer card is installed. If you assign aslot the value 9991, the mainframe will operate as if a 4 × 10matrix card is installed in that slot. These simulators allowyou to develop a test program even though the card is not installedin the mainframe.The TYPE menu selection displays an assignment messagefor each slot. In general, the Model 7002 mainframe detects4-37