Model 7002Switch System Instruction Manual - Advanced Test ...

IEEE-488 ReferenceTrigger subsystemQuerycommands:CONTinuous?Short-form format:Response message:Query continuous initiation:init:cont?1 (on) or 0 (off)DescriptionWhen continuous initiation is selected (ON), the instrument is taken out of the idle state. At theconclusion of all programmed operations, the instrument will return to Arm Layer 1. This is anoverlapped command (see *OPC, *OPC?, *TRG and *WAI).NOTEIn the event of a “Too many channels closed” error, all channels will open, theinstrument will go into idle, and continuous initiation will disable (:INI-Tiate:CONTinuous OFF).ProgrammingexampleOUTPUT 707; “:init:cont on”! Select continuous initiation5.18.2:ABORt:ABORtAbort operationShort-formformat:aborDescriptionWhen this action command is sent, the Model 7002 will abort its current operations and returnto the top of the Trigger Model (idle state). If the *OPC command has been sent, the OPC bit inthe Standard Event Status Register will set. If continuous initiation is disabled, the instrumentwill go into the idle state. If continuous initiation is enabled, operation will continue on into ArmLayer 1.The abort command will reset the Source Bypasses of the Trigger Model and reset the scanpointer back to the first channel in the scan list.ProgrammingexampleOUTPUT 707; “:abor”! Abort operation5.18.3:IMMediate:ARM[:SEQuence[1]][:LAYer[1]]:IMMediate:ARM[:SEQuence[1]]:LAYer2:IMMediate:TRIGger:[:SEQuence[1]]:IMMediateBypass arm control sourceBypass scan control source and delayBypass channel control source and delayShort-formformats:arm:imm:arm:lay2:imm:trig:imm5-134