FLK Gas Sampling System - MPIP - Free

SQ251 FLK Gas Sampling Probe
1. Introduction
1.1 General information
Warning!
This system is operated by electricity. When operating electrical equipment, it is unavoidable
that certain parts of this system carry a dangerous voltage.
If the warning information is not followed, serious bodily injury and/or material damage may
occur.
Only appropriately qualified personnel should work on this equipment or in its vicinity. These
persons must be thoroughly acquainted with all the warnings and maintenance precautions in
accordance with this manual.
The proper and safe operation of this device requires correct transport, storage, mounting
and mounting as well as proper operation and maintenance.
In particular the general construction and safety regulations about working on power
installations (e.g. DIN, VDE) should be followed as well as the regulations relating to the
proper use of lifting equipment and tools and the use of personal protective gear (protective
goggles, etc.).
1.2 Personnel qualification requirements
As understood in this operating manual and on warning notices qualified personnel are persons who are
acquainted with the mounting, mounting, maintenance and operation of this product and who possess appropriate
qualifications for their occupation, such as for example covering:
- training or instruction, and authorization for installing, removing, earthing and labelling power circuits,
equipment and systems according to the currently valid standards of safety engineering,
- training or instruction according to the currently valid standards of safety engineering in the care and use of
adequate safety equipment;
- training in first aid.
This product left our factory in a perfectly safe condition. In order to maintain this condition and ensure the safe
operation of the device, the information and warning notes given in this manual must be observed.
1.3 Field of application
The sampling probe is used for the continuous sampling of hot, aggressive and dust-laden flue gases such as
NO, CO, CO 2
, O 2
and SO 2
, from rotary kiln or precalcination chambers. It is an unpressurized, liquid-cooled, dry
probe. The length of the probe can be adapted to different installation locations.
Copyright ® SIEMENS Page 33 04/04