FLK Gas Sampling System - MPIP - Free

SQ256 Retraction Device
1. Introduction
1.1 General information
Warning!
This system is operated by electricity. When operating electrical equipment, it is unavoidable
that certain parts of this system carry a dangerous voltage.
If the warning information is not followed, serious bodily injury and/or material damage may
occur.
Only appropriately qualified personnel should work on this equipment or in its vicinity. These
persons must be thoroughly acquainted with all the warnings and maintenance precautions in
accordance with this manual.
The proper and safe operation of this device requires correct transport, storage, mounting
and mounting as well as proper operation and maintenance.
In particular the general construction and safety regulations about working on power
installations (e.g. DIN, VDE) should be followed as well as the regulations relating to the
proper use of lifting equipment and tools and the use of personal protective gear (protective
goggles, etc.).
1.2 Personnel qualification requirements
As understood in this operating manual and on warning notices qualified personnel are persons who are
acquainted with the mounting, mounting, maintenance and operation of this product and who possess appropriate
qualifications for their occupation, such as for example covering:
- training or instruction, and authorization for installing, removing, earthing and labelling power circuits,
equipment and systems according to the currently valid standards of safety engineering,
- training or instruction according to the currently valid standards of safety engineering in the care and use of
adequate safety equipment;
- training in first aid.
This product left our factory in a perfectly safe condition. In order to maintain this condition and ensure the safe
operation of the device, the information and warning notes given in this manual must be observed.
1.3 Field of application
For the application of the motor-driven retraction device for inserting and withdrawing the gas-sampling probe, the
following points are decisive with respect to the manual mounting and to the retraction device itself:
- Application conditions of the probe in the hot kiln region
- Weight of approx. 130 kg
- When a fault occurs, the gas-sampling probe can be retracting quickly from the kiln to protect it from damage.
- Baked-on materials on the cooling pipe of the probe are stripped off by "Retraction / Insertion" of the probe.
- Automation of the insertion and retraction increases the convenience and safety in operation.
- The maintenance effort is reduced.
- It enables a centralized assembly of the sampling pipe, valve combination and dust removal filter.
Copyright ® SIEMENS Page 95 04/04