obd2cartool.com Tech-2-User-Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SECTION VIIC<br />
SERVICE PROGRAMMING SYSTEM<br />
8. At the Calibration Selection screen (Figure VIIC-7):<br />
• Select the appropriate calibration(s).<br />
• Make sure all folder tabs have a green check mark.<br />
• Select Next.<br />
9. At the Summary screen (Figure VIIC-9):<br />
• Verify current calibration(s) with selected calibration(s).<br />
• Select Next.<br />
IMPORTANT<br />
Some vehicles will require that Idle Learn, TP Learn, Theft Deterrent Relearn, or Crankshaft Variation<br />
Learn procedures be performed after programming. Consult the appropriate service information for<br />
these procedures.<br />
• If calibrations are the same, the NAODRUI Control box will appear (Figure VIIC-10). Select OK.<br />
• On model year 1996 and newer controllers, a Crankshaft Position notice may appear under<br />
“Controller Specific Instructions” on the Program Controller screen. Select OK.<br />
• The Transfer Data screen appears (Figure VIIC-11) as reprogramming begins, finishing when the<br />
percentage bar reaches 100 per cent. This may take up to 30 minutes.<br />
Pass-Thru Programming continued on next page...<br />
2005 <strong>Tech</strong> 2 <strong>User</strong>’s <strong>Guide</strong> VII - 53
Change language