obd2cartool.com Tech-2-User-Guide
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SECTION VIIC<br />
SERVICE PROGRAMMING SYSTEM<br />
18. After programming is <strong>com</strong>plete, toggle the J-45211 switch off, and wait until the green LEDs turn off<br />
before continuing or disconnecting any connectors.<br />
19. Turn off the <strong>Tech</strong> 2 and disconnect it from the J-45211.<br />
20. Disconnect the J-45211 from the PCM.<br />
21. Disconnect the power clips from the vehicle battery terminals.<br />
22. Reconnect the vehicle harness connectors to the PCM and reinstall PCM.<br />
23. Connect the <strong>Tech</strong> 2 to the DLC connector under the instrument panel, and start the engine.<br />
24. Turn the <strong>Tech</strong> 2 on, “build” the vehicle, and select Diagnostic Circuit Check, then Clear All DTCs.<br />
Note: This will clear all DTCs in all control modules simultaneously.<br />
25. If the Service Engine Soon light <strong>com</strong>es back on after clearing DTCs, another problem may be present<br />
or a CKP System Variation Learn Procedure may need to be performed. Follow existing service<br />
manual procedures.<br />
2005 <strong>Tech</strong> 2 <strong>User</strong>’s <strong>Guide</strong> VII - 65
Change language