obd2cartool.com Tech-2-User-Guide
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
VCI MODULE DIAGNOSTIC CHART<br />
Test Results Solution<br />
MUX<br />
(Multiplexer)<br />
MUX A:<br />
MUX B:<br />
S5 & S14<br />
pass/fail<br />
S1 & S3<br />
pass/fail<br />
If MUX A or B fails, cycle <strong>Tech</strong> 2 power and retest.<br />
If problem persists, contact Customer Support.<br />
VCI adapter ID<br />
(performed only during<br />
selectable VCI test)<br />
VCI ADC<br />
(Analog to digital converter)<br />
Cross point<br />
SIPO<br />
(Serial In Parallel Out)<br />
DLC<br />
(Data Link Connector)<br />
CCD<br />
(Chrysler Collision Detection)<br />
Recognized adapter<br />
Cannot identify adapter<br />
Channel A - pass/fail<br />
Channel B - pass/fail<br />
Pull up - pass/fail<br />
TPU5, TPU1, and TPU0 - pass/fail (results<br />
from selectable VCI test)<br />
Pass/fail for each area tested<br />
DLC1 - DLC2<br />
pass/fail count<br />
DLC2 - DLC1<br />
pass/fail count<br />
CCD - pass/fail<br />
CCD - loopback not connected<br />
If adapter fails, use a different adapter to make sure<br />
that the VCI correctly identifies the adapters.<br />
Cycle <strong>Tech</strong> 2 power and retest failed adapter. If adapter<br />
fails second test, contact Customer Support.<br />
If channel A or channel B fail, cycle <strong>Tech</strong> 2 and retest.<br />
If problem persists, contact Customer Support.<br />
If a failure occurs, cycle <strong>Tech</strong> 2 and retest.<br />
If problem persists, contact Customer Support.<br />
If a failure occurs, cycle <strong>Tech</strong> 2 and retest.<br />
If problem persists, contact Customer Support.<br />
If a failure occurs, cycle <strong>Tech</strong> 2 and retest.<br />
If problem persists, contact Customer Support.<br />
Connect loopback and retest if loopback not connected.<br />
If test fails, disregard results. Test is not for GM vehicles<br />
(other than Saab) at this time.<br />
Continued on next page...