obd2cartool.com Tech-2-User-Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SECTION VIIC<br />
SERVICE PROGRAMMING SYSTEM<br />
11. A Transfer Data screen will appear (Figure VIIC-11). The PC will automatically load the calibration into<br />
the control module.<br />
12. When programming is <strong>com</strong>plete, a Program Controller “Programming Complete” screen appears.<br />
Follow the on-screen instructions (if any), then select Close.<br />
13. Power off the OBPA, then power off the scan tool (wait 30 seconds after OBPA is shut off before<br />
disconnecting the control module in order to allow the controller to reset).<br />
14. Disconnect the OBPA from the <strong>Tech</strong> 2 and the control module. (Refer to figures VIIC-37 and VIIC-38.)<br />
2005 <strong>Tech</strong> 2 <strong>User</strong>’s <strong>Guide</strong> VII - 62
Change language