obd2cartool.com Tech-2-User-Guide
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SECTION III<br />
GETTING STARTED<br />
PCMCIA Card Removal<br />
The PCMCIA Card is accessed by opening the hinged door located at the top of the <strong>Tech</strong> 2. The card is<br />
found in the upper slot. The lower slot will be used for future enhancements. Press the arrow button<br />
(located beside the slot) to eject the card (Figure III-8).<br />
Figure III-8<br />
Ejection of PCMCIA card<br />
PCMCIA Card Insertion<br />
The PCMCIA Card is keyed with two notches on one side and one notch on the other side (Figure III-9).<br />
Make sure that the notches are in the correct position before inserting the card. Slowly insert the card<br />
(Figure III-10) until it clicks into place.<br />
Figure III-9<br />
PCMCIA card keying<br />
Figure III-10<br />
PCMCIA card insertion<br />
NOTICE<br />
Use only GM Service and Parts Operations supplied PCMCIA cards. The PCMCIA slots are designed<br />
to interface with 5-volt cards. Permanent damage to <strong>Tech</strong> 2 could occur if a 3.3-volt card is inserted into<br />
the <strong>Tech</strong> 2 PCMCIA connector.<br />
2005 <strong>Tech</strong> 2 <strong>User</strong>’s <strong>Guide</strong> III - 3
Change language