N-(1,3-Dimethylbutyl)-N

More documents

Recommendations

Info

OECD SIDS N-(1,3-DIMETHYLBUTYL)-N´-PHENYL-1,4-PHENYLENEDIAMINE 3. ENVIRONMENTAL FATE AND PATHWAYS ID: 793-24-8 DATE: 11.05.2005 1 Hydrogen (Hydrogen to oxygen bonds) 3.2318 1 Hydrogen (Hydrogen to nitrogen bonds) 1.2835 12 Fragments (Cyclic aromatic [Car] to Car) 3.1657 1 Fragment (Car-OH) 0.5967 2 Fragments (Car-N) 1.4608 Total: 8.350 HENRYs LAW CONSTANT (HLC) at 25 °C = 1.09E-010 atm-m3/mole = 4.47E-009 unitless HLC [Vapour pressure/water solubility estimate using EPI values: vapour pressure 4.03E-005 mm Hg, water solubility 170 mg/l]: 5.781E-008 atmm3/mole Result : Bond Estimation for 4-hydroxydiphenylamine: 1.09E-010 atm-m3/mole = 1.08E-5 Pa-m3/mole Calculation from Vapour pressure/water solubility for 4- hydroxydiphenylamine: 5.781E-008 atm-m3/mole = 5.707 E-003 Pam3/mole Test substance : 4-Hydroxydiphenylamine Reliability : (2) valid with restrictions Accepted calculation method Flag : Critical study for SIDS endpoint 20.01.2005 (32) Media : water – air Method : other (calculation): HENRYWIN (v3.10) Year : 2003 Method : Calculation from calculated vapour pressure and calculated water solubility: Vapour pressure: 4.93E-006 mm Hg = 0.00064 Pa Water solubility: 1.88 mg/L Result : Henry law constant (HLC) at 25 deg C = 0.092 Pa m3 mol-1 Henry law constant calculated by EPIWIN is smaller than the result obtained by the method of Thomas because data input was different. Vapour pressure [.00064 Pa] was 10 times higher than the one calculated by Bayer [Bayer AG (1994) Berechnung des Dampfdruckes bei 25 °C für 6PPD (unpublished report)]. The water solubility data (1.88 mg/l) was approximately twice the measured value, thus resulting in an overestimate of the HLC. Reliability : (2) valid with restrictions Accepted calculation method 20.01.2005 (27) Media : water – air Method : other (calculation): HENRYWIN (v3.10) Year : 2003 Method : Bond Estimation Method Remark : Data used in the calculation: Temperature (°C): 20 Molar Mass (g/mol): 268.41 Vapor pressure (Pa): 6.85E-7 Water Solubility (g/m3): 1.1 Result : Henrys law constant at 25 deg C = 3.36E-009 atm m3 mol-1 = 1.37E-007 unitless = 3.39E-004 Pa m3 mol-1 Reliability : (2) valid with restrictions Accepted calculation method 28.01.2005 (27) Media : water – soil Method : other (calculation): EPIWIN PCKOC Year : 2004 66 UNEP PUBLICATIONS
OECD SIDS N-(1,3-DIMETHYLBUTYL)-N´-PHENYL-1,4-PHENYLENEDIAMINE 3. ENVIRONMENTAL FATE AND PATHWAYS ID: 793-24-8 DATE: 11.05.2005 Method : Used program: EPIWIN PCKOC First Order Molecular Connectivity Index: 6.843 Non-Corrected log Koc: 4.2622 Fragment Correction(s) for Nitrogen to non-fused aromatic ring: -0.7770 Result: Corrected log Koc: 3.4852 Remark : The Koc of this structure may be sensitive to pH! The estimated Koc represents a best-fit to the majority of experimental values, however, the Koc may vary significantly with pH. Result : For 4-hydroxydiphenylamine [phenol, 4-(phenylamino)-] the Koc (estimated) equals 3056 Since the compound is an amine, Koc may be sensitive to pH! Reliability : (2) valid with restrictions Accepted calculation method Flag : Critical study for SIDS endpoint 28.01.2005 (32) 3.4 MODE OF DEGRADATION IN ACTUAL USE Memo : Reaction products of ozonation Method : A film of TS was aged for one week under 0.5 ppm ozone in air at 40°C, and the reaction products were identified Remark : In rubber articles, the antiozonant diffuses to the rubber surface and reacts with ozone ("scavenger-protected film" theory) Result : Ozonation occurs mainly with degradation of the alkyl portion of the TS. For a series of reaction products, the molecular formulas are given. Reliability : (2) valid with restrictions 05.06.2001 (14) Memo : Transformation products after production and storage Method : Analysis of technical grade TS Result : As a main impurity, up to 5% 1-phenylamino-4-(1,3-dimethylbutylamino)-3,6-bis(4-phenylami nphenylimino)-1,4-cyclohexadiene was identified Reliability : (2) valid with restrictions 14.05.2001 (7) 3.5 BIODEGRADATION Type : Aerobic Inoculum : activated sludge Concentration : 100 mg/l related to Test substance related to Contact time : 28 day(s) Degradation : 2 - 98 (±) % after 28 day(s) Result : other: Based on BOD, ca. 2 % of 6PPD was biodegraded; based on HPLC, ca. 92 % fo 6PPD was degraded Control substance : Aniline Kinetic : % % Deg. product : Method : OECD Guide-line 301 C "Ready Biodegradability: Modified MITI Test (I)" Year : 1994 GLP : Yes UNEP PUBLICATIONS 67
Page 1 and 2:
OECD SIDS N-(1,3-DIMETHYLBUTYL)-N´
Page 3 and 4:
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16: OECD SIDS N-(1,3-DIMETHYLBUTYL)-N´
Page 65: OECD SIDS N-(1,3-DIMETHYLBUTYL)-N´
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143:
show all

N-(1,3-Dimethylbutyl)-N

Create successful ePaper yourself

Delete template?

Save as template?