service manual ar-203e ar-203e x ar-m200 ar-m201 model ar-5420

6) Clean the cleaning section and the waste toner pipe to remove
waste toner completely with a vacuum cleaner.
7) Remove the felt and duplex tape completely.
Note: Be careful not to scratch or bend the sub blade.
8) Attach the cleaning blade.
Securely insert the plate section of the cleaning blade into the
unit and fix it with a screw.
Do not touch the cleaning blade rubber with your hand.
When attaching the cleaning blade, press the cleaning blade
in the arrow direction and attach.
Attach the cleaning blade, press the molt on the process frame
with a screwdriver (–), and push it in the clearance between the
process frame and the cleaning blade.
Machine F side
Machine R side
Normal state of the molt
Machine F side
Machine R side
9) Attach the moquettes.
Moquette R
AR-203E/5420/M200/M201 DISASSEMBLY AND ASSEMBLY 8 - 2
0.2 – 0.5 mm
Moquette R
∗
0 – 0.3 mm 0 – 0.3 mm
0 – 0.5 mm
∗: Check while pressing the blade.
Cleaning blade
Sub blade
Cleaning blade
Sub blade
Be careful not to allow the
moquette to cover the sub blade.
Moquette F
0 – 0.5 mm
Attach the mocket with slightly pressing section A of the cleaning
blade.
Do not touch the tip of the cleaning blade.
Do not put the mocket under the cleaning blade.
Do not put the mocket on the sub blade.
Do not press the sub blade with the mocket.
If the moquette F/R is deformed or damaged, replace it.
(Recommendable replacement cycle: Every 25K)
∗
Example of NG
0.2 – 0.5 mm
Moquette F