service manual ar-203e ar-203e x ar-m200 ar-m201 model ar-5420

Main Sub
code code
24 15 Scanner mode counter clear
(AR-203E/M200/M201)
25 01 Main motor operation check
(Cooling fan motor rotation
check)
Contents Details of function/operation
[Function]
When [OK]/[ENTER]/[START] key is pressed, the scanner mode counter value is cleared to 0,
and "000,000" is displayed on the LCD/display.
[Operation]
AR-M200/M201
1) Initial display
24-15 S-MODE CLR.
CLEARED 000,000
[Function]
When [OK]/[ENTER]/[START] key is pressed, the main motor (and the duplex motor in the case
of a duplex model) is operated for 30sec.
To reduce toner consumption, if the developing unit is installed, the developing bias, the main
charger, and the grid are also outputted.
In this case, laser discharge is required when stopping the motor, the polygon motor is also
operated at the same time. Check for installation of the developing unit. If it is not installed, the
high voltage above is not outputted and only the motor is rotated.
To check the developing bias, install the developing unit.
After completion of 30sec operation, the machine goes into the sub code entry standby mode.
[Operation] (AR-M200/M201)
1) Initial display
25-01 MAIN MOTOR CHK
EXECUTING...
10 Polygon motor ON [Function]
When [OK]/[ENTER]/[START] key is pressed, the Bios is called to rotate the polygon motor for
30sec.
After completion of 30sec operation, the operation is turned off with the Bios and the machine
goes into the sub code entry standby mode.
[Operation] (AR-M200/M201)
1) Initial display
25-10 LSU CHK
EXECUTING...
26 02 SPF/RSPF setup [Function]
When this simulation is executed, the current set SPF/RSPF is displayed. Enter the code number
corresponding to the desired SPF/RSPF and press [OK]/[ENTER]/[START] key to save the
setting.
Code number SPF/RSPF Display item
0 SPF NO SPF OFF
1 SPF YES SPF ON
2 RSPF YES RSPF ON
For the AR-203E/5420, the code number cannot be set to 2.
For the AR-M200/M201, the code number cannot be set to 1.
[Operation]
AR-M200/M201
1) The current set value is
displayed.
26-02 SPF/RSPF
1:SPF ON (0- 2)
2) [Numeric] key or [ ] key
26-02 SPF/RSPF
0:SPF OFF (0- 2)
03 Second cassette setup [Function]
When this simulation is executed, the current set second cassette is displayed. Enter the code
number corresponding to the desired second cassette and press [OK]/[ENTER]/[START] key to
save the setting.
[Operation]
The operation is similar to simulation 26-02.
2) [Numeric] key or [ ] key
26-02 SPF/RSPF
2:RSPF ON (0- 2)
3) [OK]/[ENTER]/[START]
key
26-02 SPF/RSPF
2:RSPF ON (0- 2)
AR-203E/5420/M200/M201 SIMULATION, TROUBLE CODES 10 - 13
AR-203E
The operation is similar to simulation 20-01.
Code number Second cassette Display item
0 Second cassette NO OFF
1 Second cassette YES ON
For the AR-203E/5420/M200/M201, the code number cannot be set to 1.
AR-203E/5420
1) Press [ ] [ ] key to
2)
change the code number.
Press [START] key to fix
the code number.