service manual ar-203e ar-203e x ar-m200 ar-m201 model ar-5420

10) Attach the main charger.
Securely set the MC holder on the projection of the process
frame.
Securely insert two projections of the MC holder into the
groove in the process frame.
When attaching the MC holder ass'y, be careful not to make
contact with the cleaning blade.
11) Attach the drum fixing plate and the photoconductor drum.
Apply grease to the inside of the photoconductor drum. (Dia.
2)
Attach the drum from (b). (Prevention against the sub blade
edge breakage)
Attach the drum so that its position with the sub blade is as
shown.
12) Attach the drum cover.
Note: After attaching the drum cover, do not make a copy.
When attaching the drum cover, engage the detection
gear 20T rib with the 30T gear rib, and attach the drum
cover to the process frame.
13) Insert the process unit into the machine until it is fully engaged.
C. Disassembly procedure
AR-203E/5420/M200/M201 DISASSEMBLY AND ASSEMBLY 8 - 3
1) Press the side cover open/close button and open the side
cover.
1)
2) Push up the lock pawls (2 positions) of the side cover, and
remove the transfer charger.
Transfer
charger
1)
D. Assembly procedure
For assembly, reverse the disassembly procedure.
1)
2)
Lock pawl front
Lock pawl rear
2)