Project Manual 11-210C - Ramapo College of New Jersey

More documents

Recommendations

Info

SECTION 01 40 00 – QUALITY REQUIREMENTS 1.7 REPAIR AND PROTECTION A. General: Upon completion of inspection, testing, sample-taking and similar services, repair damaged construction and restore substrates and finishes to eliminate deficiencies, including deficiencies in visual qualities of exposed finishes. Comply with Contract Document requirements for "Cutting and Patching." B. Protect construction exposed by or for quality control service activities, and protect repaired construction. C. Repair and protection is the Contractor's responsibility, regardless of the assignment of responsibility for inspection, testing or similar services. 1.8 GENERAL INSTALLATION PROVISIONS A. Inspection of Conditions: Require the Installer of each major component to inspect both the substrate and conditions under which Work is to be performed. Do not proceed until unsatisfactory conditions have been corrected in an acceptable manner. B. Manufacturer's Instructions: Comply with manufacturer's installation instructions and recommendations, to the extent that those instructions and recommendations are more explicit or stringent than requirements contained in Contract Documents. C. Inspect materials or equipment immediately upon delivery and again prior to installation. Reject damaged and defective items. D. Provide attachment and connection devices and methods necessary for securing Work. Secure Work true to line and level. Allow for expansion and building movement. E. Visual Effects: Provide uniform joint widths in exposed Work. Arrange joints in exposed Work to obtain the best visual effect. Refer questionable choices to the Architect for final decision. F. Recheck measurements and dimensions, before starting each installation. G. Install each component during weather conditions and Project status that will ensure the best possible results. Isolate each part of the completed construction from incompatible material as necessary to prevent deterioration. H. Coordinate temporary enclosures with required inspections and tests, to minimize the necessity of uncovering completed construction for that purpose. I. Mounting Heights: Where mounting heights are not indicated, install individual components at standard mounting heights recognized within the industry for the particular application indicated. Refer questionable mounting height decisions to the Architect for final decision. Ramapo College of New Jersey 01 40 00 QUALITY REQUIREMENTS E-Wing Renovation for Teacher’s Education Page 4 of 5 RCNJ Project No. 11-210C Prepared by: Cambridge Construction Management
SECTION 01 40 00 – QUALITY REQUIREMENTS 1.9 REPLACEMENT OF WORK A. Within 24 hours after rejection of work pursuant to the General Conditions, remove all materials and equipment so rejected and immediately replace work, at the Contractor's cost, to the satisfaction of the Architect and Construction Manager. Should the work of the Owner or other Contractors be damaged by such removal or replacement, the Contractor shall reimburse the Owner or other Contractors for all costs incurred for correcting damage. - END OF SECTION 01 40 00 - Ramapo College of New Jersey 01 40 00 QUALITY REQUIREMENTS E-Wing Renovation for Teacher’s Education Page 5 of 5 RCNJ Project No. 11-210C Prepared by: Cambridge Construction Management
Page 1 and 2:
E-WING RENOVATION FOR TEACHER’S E
Page 3 and 4:
18 - GENERAL CONDITIONS 19 - REQUES
Page 5 and 6:
BID REQUEST COVER SHEET (FOR CONSTR
Page 7 and 8:
***********************************
Page 9 and 10:
SUBCONTRACTORS AND THEIR REFERENCES
Page 11 and 12:
The Bidder agrees that this bid sha
Page 13 and 14:
RAMAPO COLLEGE OF NEW JERSEY STOCKH
Page 15 and 16:
CONTRACT FOR CONSTRUCTION Agreement
Page 17 and 18:
Owner Contractor Agreement 11. CONT
Page 19 and 20:
Owner Contractor Agreement ATTEST:
Page 21 and 22:
RAMAPO COLLEGE OF NEW JERSEY BID SE
Page 23 and 24:
RAMAPO COLLEGE OF NEW JERSEY PERFOR
Page 25 and 26:
RAMAPO COLLEGE OF NEW JERSEY PAYMEN
Page 27 and 28:
Ramapo College of New Jersey 505 Ra
Page 29 and 30:
(1) To notify the Public Agency Com
Page 31 and 32:
subcontractor agrees that, in imple
Page 33 and 34:
3. The executive head of each depar
Page 35 and 36:
easonable suspicion that such cause
Page 37 and 38:
E-Wing Renovation for Teacher’s E
Page 39 and 40:
Page 41 and 42:
In the procurement process, our pub
Page 43 and 44:
13. The provisions of sections 1 th
Page 45 and 46:
WHEREAS, robust competition for pub
Page 47 and 48:
incorporate good faith effort requi
Page 49 and 50:
APPENDIX A LIST OF REPORTING AGENCI
Page 51 and 52:
APPENDIX C It is the policy of the
Page 53 and 54:
Page 56 and 57:
Academic Complex Academic Wings Ang
Page 58 and 59:
• Using Route 208: Follow 208 Nor
Page 60 and 61:
THE PUBLIC WORKS CONTRACTOR REGISTR
Page 62 and 63:
(8) NJ Business Registration Certif
Page 64 and 65:
e. The Contracting Officer reserves
Page 66 and 67:
IB9.2 Every request for an interpre
Page 68 and 69:
Ramapo College of New Jersey E-Wing
Page 70 and 71:
12.2 Safety of Persons and Property
Page 72 and 73:
epresenting the College personally
Page 74 and 75:
1.2.8 The sequence of precedence pe
Page 76 and 77:
expeditiously commences to prosecut
Page 78 and 79:
ARTICLE 3 CONSTRUCTION MANAGER AND
Page 80 and 81:
ARTICLE 4 THE CONTRACTOR 4.1 Review
Page 82 and 83:
shall be provided and accomplished
Page 84 and 85:
d. Removal of spots, paint and soil
Page 86 and 87:
Drawings, Product Data, Samples or
Page 88 and 89:
4.12.3 Replace, fit, patch and repa
Page 90 and 91:
4.18.2 License and/or Royalty Fees
Page 92 and 93:
employed by any of them or anyone f
Page 94 and 95:
3. Arrange content by systems under
Page 96 and 97:
ARTICLE 6 PROJECT SPECIFIC CONDITIO
Page 98 and 99:
7.5.2 Should the Contractor elect t
Page 100 and 101:
ARTICLE 8 RELATIONSHIP BETWEEN THE
Page 102 and 103: epresentative shall meet with the C
Page 104 and 105: Consultant's analysis, would have b
Page 106 and 107: did not affect the project critical
Page 108 and 109: 10.1 Contractor Payments from the C
Page 110 and 111: (4) reasonable evidence that the Wo
Page 112 and 113: Payment Act and by the 30th day aft
Page 114 and 115: 11.1 Uncovering of Work ARTICLE 11
Page 116 and 117: 12.1 Safety Precautions and Program
Page 118 and 119: 13.1 Contractor Insurance Requireme
Page 120 and 121: ARTICLE 14 CHANGES IN THE WORK 14.1
Page 122 and 123: 14.2.8 Where the cost of property m
Page 124 and 125: ARTICLE 16 AFFIRMATIVE ACTION REQUI
Page 126 and 127: (2) To notify any minority and fema
Page 128 and 129: (E) The contractor and its subcontr
Page 130 and 131: SECTION 01 11 00 - SUMMARY OF WORK
Page 132 and 133: SECTION 01 11 05 - TIME OF COMPLETI
Page 134 and 135: SECTION 01 29 00 - PAYMENT PROCEDUR
Page 140 and 141: SECTION 01 31 19 - PROJECT MEETINGS
Page 142 and 143: SECTION 01 31 19 - PROJECT MEETINGS
Page 144 and 145: SECTION 01 33 00 - SUBMITTAL PROCED
Page 150 and 151: SECTION 01 40 00 - QUALITY REQUIREM
Page 154 and 155: SECTION 01 42 19 - REFERENCE STANDA
Page 156 and 157: SECTION 01 42 19 - REFERENCE STANDA
Page 158 and 159: SECTION 01 70 00 - CLOSEOUT 2. Resu
Page 160 and 161: SECTION 01 70 00 - CLOSEOUT 1.5 FIN
Page 162 and 163: SECTION 01 70 00 - CLOSEOUT Partial
Page 164 and 165: RAMAPO COLLEGE OF NEW JERSEY TEACHE
show all

Project Manual 11-210C - Ramapo College of New Jersey

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?