T700 User Guide.pdf - 1 PC Network Inc

Chapter 7 System Configuration
4. Save the settings and exit.
– End of Steps –
7.2 Network Configuration
7.2.1 Network Connection Settings
Context
This section introduces how to set IP network parameters by using the remote controller.
Steps
1. In the main interface, select Management > System Settings > Network > IP to open
the IP configuration interface, as shown in the figure below.
Figure 7-6 The Static IP Configuration Page
2. Set the parameters according to the actual networking type.
• If static IP mode is selected, set the parameters according to the description listed
in the table below.
Table 7-1 Static IP Parameters
Parameter Name
Work Mode
Address Type
IP Address
Subnet Mask
Description
Select a exactly mode due to your network
Select static IP
Input the IP address allocated by the administrator of the video
conference system
Input the Subnet mask address allocated by the administrator of the
video conference system
7-7
SJ-20100910163147-003|2010-11-23(R1.1)
ZTE Proprietary and Confidential