Firmware Update - Agilent Technologies

Updates via Instant Pilot (G4208A) 4
Update Information for A.05.1x Firmware
NOTE
After the update/activation of the resident firmware
• the Instant Pilot update screen shows an error (timeout) and/or
• a screen may show up for some seconds showing "Waiting for module". Ignore this message.
• the module's LED is blinking (resident mode)
• this module disappears from the system (no communication with A.06.xx)
4 Press 'Abort' and re-enter the firmware update screen.
5 Select the next LC module.
6 Repeat steps 3) to 5) until all LC modules are done.
7 Update the Instant Pilot to A.05.1x (has only main firmware).
8 Press Exit and restart the Instant Pilot.
After re-boot, the Instant Pilot shows all resident LC modules.
9 Enter the firmware update screen (More - Maintenance).
10 Select the first resident LC module (not the Controller!).
11 Press Single and start the main firmware update of this module.
12 When finshed press Exit and No to prevent a re-boot.
13 Select the next resident LC module and repeat steps 11) to 12) until all LC
modules are done.
After the update a screen may show up for some seconds showing "Waiting
for module". Ignore this message. It will be closed after some seconds.
14 Press Exit and restart the Instant Pilot.
Upgrade to Revision from A.05.xx to B.02.xx
When the Instant Pilot needs to be upgraded to a B.01.xx firmware to be
compatible with Agilent 1100/1200 series modules working on
A.06.xx/B.01.xx, follow the procedue below.
1 Enter the firmware update screen (More - Maintenance).
2 Select the first LC module (not the Controller!).
3 Press Single and start the resident firmware update of this module.
1100/1200/1290 Series Firmware Update Guide 105