MC35i AT Command Set

MC35i AT Command Set7.6 ATDI7.6 ATDI Mobile originated call to ISDN numberSyntaxExec CommandATDI[;]Response(s)If no dialtone (parameter ATX2 or ATX4):NO DIALTONEIf busy (parameter setting ATX3 or ATX4):BUSYIf connection cannot be set up:NO CARRIERAll other error reasons:+CME ERRORIf successfully connected and non-voice call (TA switches to data state):CONNECT When TA returns to command mode after call release:OKIf successfully connected and voice call:OKReference(s) PIN ASC0 MUX1 MUX2 MUX3 LastV.250 % % % ! ! ! !Command DescriptionTA attempts to set up an outgoing call to ISDN number. The termination character ";" is mandatory to set up voicecalls or to send *# codes for Supplementary Services. It must not be used for data and fax calls.Parameter DescriptionISDN numberString with maximum length of 20 characters. Allowed characters: +, 0-9, A, B, C. (str) 9/10/08Note• This command may be aborted generally by receiving a character during execution. Abortion is not possibleduring some states of connection setup such as handshaking.MC35i_ATC_V02.00nConfidential / ReleasedPage 123 of 390