MC35i AT Command Set

MC35i AT Command Set12.8 AT+CMGW12.8 AT+CMGW Write Short Messages to MemoryThe execute and write commands transmit a short message (either SMS-DELIVER or SMS-SUBMIT) from TEto memory storage . Memory location of the stored message is returned. Message status willbe set to 'stored unsent' unless otherwise given in parameter .After invoking the execute or write command wait for the prompt ">" and then start to write the message. To savethe message simply enter . After the prompt a timer will be started to observe the input.To abort writing use . Abortion is acknowledged with "OK", though the message will not be saved.SyntaxTest CommandAT+CMGW=?Response(s)OKExec CommandIf text mode (see AT+CMGF=1):AT+CMGWResponse(s) Text can be entered. /+CMGW: OKIf writing failsERROR+CMS ERRORWrite CommandIf text mode (see AT+CMGF=1):AT+CMGW=/[, [/][, ]] Text can be entered. /Response(s)+CMGW: OKIf writing fails see notes below.Write CommandIf PDU mode (see AT+CMGF=0):AT+CMGW=[, ] PDU can be entered. /Response(s)+CMGW: OKIf writing fails see notes below.Reference(s) PIN ASC0 MUX1 MUX2 MUX3 LastGSM 07.05 % % % % % ! !Notes• If writing fails, for example, if a message is too long, the result code depends on the current setting of theAT^SM20 command:If the AT^SM20 =1 (factory default) any failure to send a message is responded with "OK". Usersshould be aware, that despite the "OK" response, the message will not be written to the selected SMS storage.If the AT^SM20 equals 0 any failure to write a message is responded with "ERROR".MC35i_ATC_V02.00nConfidential / ReleasedPage 266 of 3909/10/08